skip to main content
Idioma:

Mechanical behavior of additive manufactured, powder-bed laser-fused materials

Mower, Todd M. ; Long, Michael J.

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2016-01, Vol.651, p.198-213 [Periódico revisado por pares]

Elsevier B.V

Texto completo disponível

Citações Citado por
  • Título:
    Mechanical behavior of additive manufactured, powder-bed laser-fused materials
  • Autor: Mower, Todd M. ; Long, Michael J.
  • Assuntos: Additives ; Aluminum alloys ; Aluminum base alloys ; Austenitic stainless steels ; Construction materials ; Cyclic fatigue ; Fatigue failure ; Fatigue strength ; Heat resistant steels ; Mechanical properties ; Microstructure ; Powder-bed fusion ; Precipitation hardening steels ; Stainless steel alloys ; Stainless steels ; Stress-strain relationships ; Titanium alloys ; Titanium base alloys
  • É parte de: Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2016-01, Vol.651, p.198-213
  • Notas: ObjectType-Article-1
    SourceType-Scholarly Journals-1
    ObjectType-Feature-2
    content type line 23
  • Descrição: Mechanical behavior of four metallic alloys fabricated with layered, laser-heated methods of additive manufacturing (AM) was compared to that of similar alloys produced with conventional methods (wrought and machined). AM materials were produced by a leading commercial service provider, as opposed to incorporating material specimens produced by unique or specially-adapted equipment. The elastic moduli were measured in flexure, stress–strain characteristics were measured in tensile deformation, and fatigue strengths were measured in fully reversed bending. The effects of fabrication orientation, surface polishing, and hot isostatic pressing upon mechanical behavior were studied. The fatigue strengths exhibited by SLM AlSi10Mg and DMLS Ti6Al4V in the as-fabricated condition proved to be significantly inferior to that of conventional material. These lower fatigue strengths are a consequence of multiple fatigue cracks initiating at surface defects, internal voids and microcracks, and growing simultaneously during cyclic loading. Measured fatigue strengths of DMLS 316L and 17-4PH approached those of corresponding wrought materials when subjected to principal stresses aligned with the build planes. When cyclic stresses were applied across the build planes of the DMLS stainless steels, fatigue fractures often developed prematurely by separation of material. Post-processing the DMLS Ti6Al4V and SS316L with hot isostatic pressure elevated the fatigue strength significantly. Measurements of surface roughness with an optical profilometer, examinations of the material microstructures, and fractography contribute to an understanding of the mechanical behavior of the additive materials.
  • Editor: Elsevier B.V
  • Idioma: Inglês
Voltar para lista de resultados

  • Realização: ABCD-USP USP   Logos de Redes Sociais: Freepik

Buscando em bases de dados remotas. Favor aguardar.