Idioma:

Micro-CT-based improvement of geometrical and mechanical controllability of selective laser melted Ti6Al4V porous structures

Van Bael, S. ; Kerckhofs, G. ; Moesen, M. ; Pyka, G. ; Schrooten, J. ; Kruth, J.P.

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2011, Vol.528 (24), p.7423-7431 [Periódico revisado por pares]

Kidlington: Elsevier B.V

Texto completo disponível

Citações Citado por

Enviar para

Título:
Micro-CT-based improvement of geometrical and mechanical controllability of selective laser melted Ti6Al4V porous structures
Autor: Van Bael, S. ; Kerckhofs, G. ; Moesen, M. ; Pyka, G. ; Schrooten, J. ; Kruth, J.P.
Assuntos: Controllability ; Cross-disciplinary physics: materials science; rheology ; Engineering, computing & technology ; Exact sciences and technology ; Ingénierie, informatique & technologie ; Lasers ; Materials science ; Materials science & engineering ; Mechanical characterization ; Phase diagrams and microstructures developed by solidification and solid-solid phase transformations ; Physics ; Pore size ; Porosity ; Porous materials ; Porous materials; granular materials ; Powder metallurgy ; Science des matériaux & ingénierie ; Solidification ; Specific materials ; Three dimensional ; Titanium alloys ; Titanium base alloys ; Tomography
É parte de: Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2011, Vol.528 (24), p.7423-7431
Notas: ObjectType-Article-2
SourceType-Scholarly Journals-1
ObjectType-Feature-1
content type line 23
scopus-id:2-s2.0-79960653088
Descrição: ► Selective laser melting as a production tool for porous Ti6Al4V structures. ► Significant mismatch between designed and as-produced properties. ► Decreasing mismatch using a micro-CT-based protocol. ► Mismatch of pore size decreased from 45% to 5%. ► Increased morphological controllability increases mechanical controllability. Despite the fact that additive manufacturing (AM) techniques allow to manufacture complex porous parts with a controlled architecture, differences can occur between designed and as-produced morphological properties. Therefore this study aimed at optimizing the robustness and controllability of the production of porous Ti6Al4V structures using selective laser melting (SLM) by reducing the mismatch between designed and as-produced morphological and mechanical properties in two runs. In the first run, porous Ti6Al4V structures with different pore sizes were designed, manufactured by SLM, analyzed by microfocus X-ray computed tomography (micro-CT) image analysis and compared to the original design. The comparison was based on the following morphological parameters: pore size, strut thickness, porosity, surface area and structure volume. Integration of the mismatch between designed and measured properties into a second run enabled a decrease of the mismatch. For example, for the average pore size the mismatch decreased from 45% to 5%. The demonstrated protocol is furthermore applicable to other 3D structures, properties and production techniques, powder metallurgy, titanium alloys, porous materials, mechanical characterization, tomography.
Editor: Kidlington: Elsevier B.V
Idioma: Inglês

Links

View record in Pascal Francis

Voltar para lista de resultados

Realização: Logos de Redes Sociais:

Micro-CT-based improvement of geometrical and mechanical controllability of selective laser melted Ti6Al4V porous structures

Van Bael, S. ; Kerckhofs, G. ; Moesen, M. ; Pyka, G. ; Schrooten, J. ; Kruth, J.P.

Kidlington: Elsevier B.V

Buscando em bases de dados remotas. Favor aguardar.