skip to main content
Idioma:

AES characterization of oxide films formed on nickel-base alloys at Supercritical Water Reactor (SCWR) conditions

Maffiotte, C. ; Sáez-Maderuelo, A. ; Gómez-Briceño, D.

Surface and interface analysis, 2016-07, Vol.48 (7), p.680-684 [Periódico revisado por pares]

Bognor Regis: Blackwell Publishing Ltd

Texto completo disponível

Citações Citado por
  • Título:
    AES characterization of oxide films formed on nickel-base alloys at Supercritical Water Reactor (SCWR) conditions
  • Autor: Maffiotte, C. ; Sáez-Maderuelo, A. ; Gómez-Briceño, D.
  • Assuntos: AES ; Alloy 690 ; Alloy 800 ; corrosion ; Ferrous alloys ; Nickel base alloys ; Nuclear engineering ; Nuclear power generation ; Nuclear reactor components ; Nuclear reactors ; Oxides ; SCWR ; Shot peening ; Superalloys
  • É parte de: Surface and interface analysis, 2016-07, Vol.48 (7), p.680-684
  • Notas: ArticleID:SIA5906
    ark:/67375/WNG-B1PJCB04-J
    istex:ACFABBAD855A3213415D68F3929DDEF253BB3874
    ObjectType-Article-1
    SourceType-Scholarly Journals-1
    ObjectType-Feature-2
    content type line 23
  • Descrição: Austenitic alloys have shown good resistance to corrosion under light water reactor operating conditions. By this reason, these materials have been considered to be part of the new supercritical water reactor, one of the highly efficient, low waste production and simply designed Generation IV nuclear reactors. The water chemistry control and the material response to corrosion in operating conditions of the supercritical water reactor take an outstanding interest in order to minimize the release of corrosion products and their subsequent transformation into radioactive products. One nickel‐base alloy, Alloy 690TT, and one austenitic stainless steel, Alloy 800 mod, were studied under supercritical water conditions (500 °C, 25 MPa and 8 ppm of dissolved oxygen). The effect of shot‐peening surface finish was also studied on Alloy 800 mod. The corrosion rate of these alloys was evaluated by means of gravimetry. Surface analysis and subsequent depth profiles were made using Auger electron spectroscopy in order to characterize the oxide films (quantitative composition and thickness) of the different alloys as well as the influence of shot‐peening on the oxidation process. According to these results, it can be concluded that shoot‐peening favours the incorporation of chromium to the oxide layer in case of Alloy 800 mod, and the thickness of the oxide layer on Alloy 690TT is higher than on Alloy 800 mod. Copyright © 2015 John Wiley & Sons, Ltd.
  • Editor: Bognor Regis: Blackwell Publishing Ltd
  • Idioma: Inglês
Voltar para lista de resultados

  • Realização: ABCD-USP USP   Logos de Redes Sociais: Freepik

Buscando em bases de dados remotas. Favor aguardar.