Idioma:

Pulsed PECVD deposition of diamond-like carbon films

Fedosenko, G. ; Schwabedissen, A. ; Engemann, J. ; Braca, E. ; Valentini, L. ; Kenny, J.M.

Diamond and related materials, 2002-03, Vol.11 (3-6), p.1047-1052 [Periódico revisado por pares]

Amsterdam: Elsevier B.V

Texto completo disponível

Citações Citado por

Enviar para

Título:
Pulsed PECVD deposition of diamond-like carbon films
Autor: Fedosenko, G. ; Schwabedissen, A. ; Engemann, J. ; Braca, E. ; Valentini, L. ; Kenny, J.M.
Assuntos: Chemical vapor deposition (including plasma-enhanced cvd, mocvd, etc.) ; Cross-disciplinary physics: materials science; rheology ; Deposition conditions ; Diamond-like carbon ; Exact sciences and technology ; Materials science ; Methods of deposition of films and coatings; film growth and epitaxy ; Physics ; Physics of gases, plasmas and electric discharges ; Physics of plasmas and electric discharges ; Plasma applications ; Pulsed PECVD ; Pulsed RF bias
É parte de: Diamond and related materials, 2002-03, Vol.11 (3-6), p.1047-1052
Descrição: Diamond-like carbon (DLC) films were deposited in a RF–RF plasma system employing a radio frequency (RF) powered substrate holder with an additional RF (13.56 MHz) driven, planar hollow cathode discharge (HCD-P) plasma source. Typically, the HCD plasma source was operated at 400 W (cw). To control the film properties as well as the balance of film deposition and simultaneous etching, the substrate holder power was modulated with a frequency of 100 Hz. The duty cycle was varied between 20 and 100% while keeping the time-averaged power fixed at 240 W. A mixture of argon, helium (1:1) and acetylene were used as carrier gases and carbon source, respectively. The influence of the duty cycle applied to the substrate holder on the deposition process and film quality were investigated by Raman spectroscopy, Fourier transform infrared (FTIR), ellipsometry and nanohardness measurements. All films show a broad Raman peak, centered at approximately 1530 cm−1 (G-peak), as well as a lower frequency shoulder at approximately 1350 cm−1 (D-peak), a feature typical for DLC films. Refractive indices between 2.1 and 2.2 (at λ=632 nm) were measured. A nanohardness of up to 17.5 GPa has been obtained. Although the deposition rate increases with increasing duty cycle, it does not scale linearly. Even at duty cycles ≤50% deposition rates of approximately 100 nm/min were obtained, compared to 130 nm/min for cw operation of the substrate holder. Furthermore, we found that pulsed PECVD of DLC films reduces the compressive stress and improves adhesion, e.g. on stainless steel substrates.
Editor: Amsterdam: Elsevier B.V
Idioma: Inglês

Links

View record in Pascal Francis

Voltar para lista de resultados

Anterior Resultado 6 Avançar Ir para próxima página

Realização: Logos de Redes Sociais:

Pulsed PECVD deposition of diamond-like carbon films

Fedosenko, G. ; Schwabedissen, A. ; Engemann, J. ; Braca, E. ; Valentini, L. ; Kenny, J.M.

Amsterdam: Elsevier B.V

Buscando em bases de dados remotas. Favor aguardar.